Sorry, this item sold. You may also like:
Made of 3/4 inch pine, This is stained and varnished in walnut stain can also do, RedOak, ebony Gunstock and Golded peacan avalible also. This can also be left natural with varnish only.
This includes up to 5 letters, more the letters would be smaller, contact me for price.
Stain colors can vary and can take stain lighter or darker as each piece of wood is different.
Finger gap in the front so littlen fingers are not as easily pinched. Constant Friction Safety Lid Support Hinge.
Rope Handles, Hardboard bottom.
Pre-assembled sections (Assembly Required) These are the instuctions for assembly of the 6 panels.
Assembly of Pine Toy Box
It is best to assemble on a flat surface with the legs touching flat on the surface. If you do not have them on a flat surface the toy bax when assembled may not set flat and rock some.
1. Each corner at the top of each joint has a colored sticker attached. There are 4 colors used. Stickers are placed on the inside of the box, these can be removed after assembly.
2. Lay out all four of the corners of the sides and front and back matching the color codes together. There are 4 pre-drilled holes for each corner, use a Drill with a phillips bit[ this the best way] or a screw driver and 4 -2 inch screws and assemble your first corner, continue with each corner until you have attached all 4 sides. [Caution if you use a drill to drive the screws in or a screw driver, do not over tighten as over tighten can cause the board to crack.]
3.Next lay the bottom hardboard on the ledges in the bottom of the box and attach with small screws provided.
4. The top has the hinges already attached, lay the top on and line up the pre-drilled holes on the back of the box with the lid, use the 4 screws provided to attach the top to the bottom with the hinges.
5. Install the pressure resistant hinge: use in the 4 screws and hinge/ this is placed just off center inside the box at the back portion of the top and back of the box.
You box has is now assembled.
Please note these are made from pine,, there may also be variations in wood color as pine will have darker grain patterns
Section are not only nailed they are glued at nail joints to incraese strenght. Many others only nail theirs and they come apart in a short time,
Shipping weight on this is 35-40 lbs,
West coast, Califonia, Oregon and Washington State, shipping is higher, please contact me for a shipping quote
Dimensions: 31 1/2”W x 17”H x 17”D
"If you are not satisfied for any reason, please convo me. I will do everything possible to make it right."
If you are not happy with your purchase, you have 7 days to contact me to return the product for the purchased price refund , minus shipping charges. Buyer to pay for return shipping.