3/4 inch thick, 5 1/2 inches high, 18 inches long.
The Rack outer surface protrudes 4 1/4 inches from the wall surface. Outer surfaces of the base are sanded to a 220 / 240 grit finish, sealed and Danish Oil applied in 3 coats. After curing, then 2 coats of wipe on polyurethane is applied. After finish coating, the "Hooks" are attached using mechanical fasteners. These are heavy, smooth premium hooks, polished and coated.
You will need to Drill 2 through holes in the base of the rack, so that they will be located over wall studs. It is highly recommended that this rack be attached at locations where the wall studs will provide the anchoring needed to carry the weight of your coats, hats, and anything you wish to hang on it. (An alternative, though weaker, is to use Wall Anchors through the Wall Board and Rack base. - this is dependant on the strength of the Wall Board)
A customized version of this rack is available on special order, either shorter or longer (Up to 5 feet in length) with additional hooks, equally spaced. Shipping charges, finish costs, and the price for added hooks will change the price on the unit. ("Convo" me for any special requirements, and we will get back to you with a price including the added wood, extra hooks required and shipping costs.) We can also build this as a KIT, where the Rack Backing would be finish machined and sanded, pilot holes drilled for mounting the hooks, but without any finish applied. That way you coulc apply any finish you wanted, locate the board on the wall where needed, then simply attach the hooks to the rack with the included screws. The Hooks would all be prelocated for you. Once specifications were agreed to, and the price and shipping are agreed to, we would post a special order for you in the store where you could then purchase the item.
Whats included in this listing::
1 - Coat and Hat Rack Assy w/2 Coat Hooks inches long, finished in Med Walnut.
2 - 2 1/2 inch Screws - Phillips Head for mounting to the wall
1 - Instruction sheet
1 - Finish machined board
2 - two Pewter cast hooks and screws to mount
3 - Instruction sheet
To install you will need:
Electric Power Drill w/ 1/8 bit
Stud Finder, Level, Phillips Head Screw Driver (or bit for use with a power driver), Standard tape measure.
Check out our Facebook Page and Website for more info, newsletter sign-ups and specials. You can reach these sites from the "Links" on our "About" page. The website has links back to Etsy, and the facebook "Store" is linked to Etsy.
Don't forget to "Like Us" on facebook.