- 1" angle iron construction.
- 24" Tall.
- Black powder coat finish.
- all mounting hardware
- Made in the USA using American Products and labo
- Please note toe push is only on 42" stake not on 24".
Please read below for mounting instructions.
For displaying your plaque on a stake driven into the ground or your stake embedded in concrete.
We install screw inserts into the back of your plaque that match with holes on the stake that you purchase from us. After the stake is driven into the ground, attach the plaque to the stake using the supplied screws.
You will receive your plaque with steel cross-bar mounting braces already attached. The vertical post first needs to be inserted into the ground at the desired location before proceeding. Do not mount the plaque before the stake is ready to accept it.
First, push the stake into the ground or in set in concrete. Then Attach your plaque to the stake with the supplied screws. Caution - Just snug only on the attaching screws. Do not over-tighten. Your installation is complete and you can take the rest of the day off!
Some care is required. Your plaque is made of High Density Sign Board, which has many of the strength characteristics of soft wood. It can be dented. The metal coating adds a thin layer of hard material, but the plaque can be dented through the metal. Your plaque is light-weight and does not require much mechanical strength to hold it. Screws should not be over-tightened. Just a light contact with the plaque is sufficient and will avoid damage to the plaque or inserts.