***
Dimensions: 4-1/4”w x 3/4”h (10.8cm x 1.9cm)
Please note, an additional 6.35% sales tax will be charged to Connecticut residents.
Thanks for looking!
~~~~~
A little something about my fusings...
With every kilnformed creation, my goal is to craft the best piece that I can, and to do this I use many of the same techniques employed by professional glass artists. Whether it's a plate, piece of jewelry, or a fun little decoration, every piece can go through anywhere from one, to three or more firings depending on the design. In most cases, the first is usually a full fuse in which all of the pieces melt together. During this step, I usually support the glass with fiber paper and kiln furniture to keep the edges from getting too wonky as they melt. At this point additional items may be tack fused and fired to the surface for dimensional pieces. In the case of plates, vases, votives, and jewelry however, there are a few more steps. After the initial full fuse, the piece will undergo some coldworking to square up the sides, clean up the surface, and shape the edges. Some of the tools I use to do this can include a cylindrical grinder, wet stone polisher, sandblaster, wet belt sander, and small diamond handpads; mostly depends on the piece and the desired finish. And then it's back into the kiln for a fire polish. If I want the piece to take a particular form, in the case of a dish for example, it is then placed on a mold and fired until it becomes the shape I'm looking for. I also make sure to give every piece a good long anneal (cool down) for strength. And when done, each piece is cleaned, polished, and signed.
NOTE: I specially design ALL of my food bearing plates to be food safe with a layer of clear glass on top. Please read the item descriptions carefully to determine which pieces meet your needs.
~~~~~
- Always keep out of reach of children!
Have any questions?
Contact the shop owner.
