suspended in time . knot a wristwatch

Description

I've always been fascinated by the inner workings of clocks and watches, so many tiny little gears intricately moving in unison. This handknit watch may not tell time, but who cares when you can be so fashionably late!

I knit this wide cuff style bracelet using delicate silver toned wire that is quite flexible and then suspended a variety of different sized and shaped watch gears into the design. There are two gold lobster claw clasps as the closure.

measurements, unstretched~
3.25" (8cm) wide
8.25" (21cm) around

As a sizing gauge, my wrist(in photos) is 6". The cuff is large enough to slide over my hand without undoing the clasps but because it is so wide, it won't slide off and the "top" side of the cuff stays in place. This will comfortably fit up to an 8" wrist while still allowing for some wiggle room. If you have very tiny wrists, you can adjust the size smaller by hooking the clasps so the bracelet ends overlap.

all contributed content © KnotOriginal

Added on Oct 22, 2009