----FREE SHIPPING ---- USA and Canada only.
--------------------------------------------------------
VERY IMPORTANT NOTE:
+Please write your PHONE NUMBER in the message box when ordering, it is needed for shipping.
+You could specify WHEN ORDERING in the COMMENTARY BOX the exact length you need to be cut and any other specification like overall length. Refer to the last image.
When the lenght is not specified we will send you the longer measurements listed. For example: if you need 32" then order 24" to 36" and make a note that you need 32".
--------------------------------------------------------
SET OF CURTAIN ROD WITH BRACKETS in real wrought iron made by an experienced blacksmith.
The set includes:
-One curtain rod of 3/4" diam. all hot hammered textured
-Two or three brackets
-Two finials with balls 3/4"
- Middle bracket when is necessary because of the length.

Note: depending on the length the rods are coming in two or three bars screwable together.

(1)The finial is screwing on the rod.

--------------------------------------------------------------------------------

MORE INFOS:

Follow this link to find more info about this product.https://forgespellidesign.wixsite.com/product-info/curtain-rod-infos

Also, you will find more about how to calculate your curtain rods on my Pinterest page
www.pinterest.ca/forgespellidesi/how-to-measure-curtain-and-rods/

DESIGN AND PROCESS:
These CURTAIN RODS are entirely hand-hammered. The ball finial is hand-hammere to give a nice and elegant shape. Made by an experimented blacksmith with ancestral and modern techniques.

MATERIAL:
These curtain rods are made with 3/4" round steel hot hammered.
Screws included.

FINISH:
Many finishes are offered. For more infos refer to the FAQ on our internet site at: https://forgespellidesign.wixsite.com/product-info/finish-and-faux-finis

CONTROL of QUALITY:
Each object is made by a blacksmith of more than thirty years of experience. He makes sure that the order is respected and practices a STRICT CONTROL OF QUALITY. The square had a tolerance of fewer than 0,5 degrees. Usually, the dimension is close to the dimension indicated but it could be more or less than 1/2'' due to the forging process in the length and the height.