DIY 3d printed Boba Fett ee-3 1:1 scale blaster replica prop from ROTJ mk-II

AprilStormProps

Have a question about the item? Send a message.

This seller usually responds within 24 hours.

DIY 3d printed Boba Fett ee-3 1:1 scale blaster replica prop from ROTJ mk-II

Message Seller

$105.00

Please select a quantity
Almost gone. There's only 3 left.

Item details

Handmade

Materials

3D Printed, ABS Plastic

The item for sale is are all the 3d printed parts to make this prop and is the same parts in the photos supplied for this listing.

<< the picture of the finished prop is there for reference only, this is a kit of parts as pictured in the first two photographs. >>

These parts will make a very close replica of the blaster used by Boba Fett in Return of the Jedi. It is scaled to be as close as possible to the MR prop and hence is approximately 83cm in overall length.

The item is 3d printed in ABS plastic, not fragile PLA so is strong and lightweight. It has also been designed to come apart into two parts for easy transport by simply removing one bolt. Also ABS is much easier to finish and sand and you can acetone weld the parts.

I will supply basic instructions but the onus is on the buyer to assemble and finish the prop:
https://medium.com/@Aprilicious1/april-storm-props-rotj-ee-3-blaster-assembly-4f718dd2c376

These have been printed at a much higher resolution than most, and detailed parts are printed at 200 micron, all done on well calibrated machines, one specifically designed for prop making. (Not CR-10s :-) )

(This is a newer version of the EE-3 Kit that has been previously sold. Its a higher grade finish printed at a much higher resolution using hi grade plastic for the best results)

International Shipping information

All props are shipped internationally using Australia Post economy air or EMS (Via Aust Post) Express services. All services are tracked.
The item for sale is are all the 3d printed parts to make this prop and is the same parts in the photos supplied for this listing.

<< the picture of the finished prop is there for reference only, this is a kit of parts as pictured in the first two photographs. >>

These parts will make a very close replica of the blaster used by Boba Fett in Return of the Jedi. It is scaled to be as close as possible to the MR prop and hence is approximately 83cm in overall length.

The item is 3d printed in ABS plastic, not fragile PLA so is strong and lightweight. It has also been designed to come apart into two parts for easy transport by simply removing one bolt. Also ABS is much easier to finish and sand and you can acetone weld the parts.

I will supply basic instructions but the onus is on the buyer to assemble and finish the prop:
https://medium.com/@Aprilicious1/april-storm-props-rotj-ee-3-blaster-assembly-4f718dd2c376

These have been printed at a much higher resolution than most, and detailed parts are printed at 200 micron, all done on well calibrated machines, one specifically designed for prop making. (Not CR-10s :-) )

(This is a newer version of the EE-3 Kit that has been previously sold. Its a higher grade finish printed at a much higher resolution using hi grade plastic for the best results)

International Shipping information

All props are shipped internationally using Australia Post economy air or EMS (Via Aust Post) Express services. All services are tracked.

Shipping & returns

Ready to ship in 2–3 weeks
From Australia
Shipping upgrades available in the cart
Returns and exchanges accepted
Exceptions may apply.

Reviews

5 out of 5 stars (515)