Whoa! You can't favorite your own shop.

Whoa! You can't buy your own item.

Whoa! You can't favorite your own item.

Whoa! You can't add your own item to a list.

Add this item to a treasury!

Close
You don't have any treasuries yet. Enter a title below to create one.
Close

This item has been added.

View your treasury.

Like this item?

Add it to your favorites to revisit it later.
Quicksilver Stereobelt Accessories for those who have 3D printed their own:
http://www.thingiverse.com/thing:501157

IF YOU ARE BUYING A FULL STEREOBELT KIT, USE ADD-ON OPTIONS WITHIN THAT LISTING.

Use pull down menu to select your combo.

- 1/4" Phone Plug - movie accurate plug to add to headphones of your choice. Fits 1/4" jack on Stereobelt kit. If you have soldering skills this is a usable plug, or it can be simply clamped to the wire for looks. NOTE: plug may vary slightly from what is shown, depending on what is available.

- Stereobelt Decals - movie accurate decals printed on polyester film. Two of everything in case of boo-boos. Need to be cut out of sheet with x-acto or scissors. Make sure surface is clean before applying.

- Cassette Tape - for those who don't have stacks of these laying around like me. Will fit Stereobelt kit. Tape will be a random selection and will vary from what is shown.

See fully illustrated Stereobelt Assembly Directions for more details on each item:
http://charlesworth-dynamics.com/2013/08/instructions.html


Stereobelt is sold separately and shown to demonstrate accessories.

Frequently asked questions about CharlesworthDynamics

3D printed objects are made by 'slicing' a digital model into many thin layers. These slices are sent to a printer that 'draws' each layer by extruding plastic through a hot nozzle.
There are a lot of different materials available now but the two most common are ABS (LEGO plastic) and PLA (biodegradable plastic) which is what Charlesworth Dynamics uses.
While the 3D prints aren't hazardous, they are not food, dishwasher or microwave safe.
They are very strong, but will break just like any plastic item if abused.
3D prints are very strong if printed properly but will break just like any plastic item if abused. Since the object is printed in layers, they will have a slightly ridged texture to them unlike a injection molded object. There is usually a 'zipper' which is a slight vertical seam that indicates where each new layer starts. They may have slight defects or blemishes and the bottom which adheres to the print bed may have some discoloration. Kit pieces may need minor clean up or trimming to fit together. This is typical of most 3D prints.
Yes, you can sand and paint 3D prints like a normal plastic model. You can even use products like Bondo Glazing and Spotting putty to minimize and smooth the 3D printed texture. Make sure to use a plastic-friendly paint.
I include a link for assembly instructions with your shipping notification, but here's a link for all assembly guides:
charlesworth-dynamics.com/2013/08/instructions.html

Please don't hesitate to contact me with any questions or recommendations.
On occasion I will also build items out of 'real' parts and hardware - typically I use vintage Film & TV equipment parts. I have made lamps out of old lenses and jewelry out of old camera parts. Keep in mind that these are all used parts and will show their wear and tear and age - it's part of their charm.

Stereobelt Accessories

$8.00+

Overview