Pip-Boy 3000 Mark IV Kit

Pip-Boy 3000 Mark IV Kit


Please select a size
Please select a quantity

Item details




I have at two of these printed in each size and ready to ship from the US at all times.

A Pip-boy kit 3D printed in ABS plastic. These are the 3D printed parts and most of the hardware. Sanding, painting and assembly of the nearly 50 parts will be required. ABS can be smoothed with acetone for a great look. Check out the link below for instructions on assembling the kit. The pipboy is available in three sizes: 100%, 108% and 115%. I am now printing some of the parts in gray and black in order to save time painting, these are the same parts that are painted gray and black in the instructions. This is the phone version, Not the Accurate Version.

Examine the drawings and the table. Measure your phone and arm then compare to the table to determine what Pipboy is the best fit.

Thanks to YTec for creating this extraordinary gadget and putting it out there. This product is the same as the one in the link below.


The project described on this page is licensed under the Creative commons - Attribution - ShareAlike license.


Hardware included
M3 nut (12x)
M3 screw 6mm (4x)
M3 screw 8mm (5x)
M3 screw 12mm (1x)
M3 screw 16mm (12x)
M3 grub screw 5mm (6x)
M3 grub screw 10mm (2x)
M3 grub screw 16mm (1x)
M4 nut (3x)
M4 screw 12mm (1x)
M4 hexagonal bolt 30mm (1x)
M4 threaded rod (45mm) (1x)
1mm steel wire (to make the spring, 10cm) (1x)
4mm black tubing 10 cm long (1x)

This kit does NOT include any electronics.

Shipping & policies

Get it fast! Ready to ship in 1–2 business days.
From San Antonio, TX

Meet Piecesofgame

Tom Headley

Tom Headley

San Antonio, Texas

This seller usually responds within a few hours.


5 out of 5 stars (343)