Whoa! You can't favorite your own shop.

Whoa! You can't buy your own item.

Whoa! You can't favorite your own item.

Whoa! You can't add your own item to a list.

Add this item to a treasury!

You don't have any treasuries yet. Enter a title below to create one.

This item has been added.

View your treasury.

Like this item?

Add it to your favorites to revisit it later.
Request a custom order and have something made just for you.
Ghostbusters Ghost Trap hose made with all authentic parts. Approximately 9 - 10' long with movie accurate Foster connectors. Body is high quality 1/4" split loom with super flexible hose.

If you already have the correct male Foster connectors, this should attach to your trap and pedal just fine.

Buy the hose fully assembled or as DIY parts - if you plan on running wires in the hose, etc DIY is the way to go. The DIY version does not include red tape.

Assembly directions included in the Deluxe Pedal Guide which you can get here: http://bit.ly/1q7Yzk0

This hose WILL NOT WORK with the 3D printed male Foster connectors I released - http://www.thingiverse.com/thing:1394492
If you intend to 3D print all the parts for your Trap and Pedal, get the DIY Hose Kit instead: http://etsy.me/22cFzT6

If you would like to have the movie accurate hose and Trap fittings, get the Deluxe Upgrade kits which include the male Foster connectors that match this hose:

Deluxe Trap Upgrade: http://etsy.me/1nwMVxH
Deluxe Pedal Upgrade: http://etsy.me/223d7Qb

Hose only - male Foster connectors not included. Trap and Pedal shown for demonstration.

Frequently asked questions about CharlesworthDynamics

3D printed objects are made by 'slicing' a digital model into many thin layers. These slices are sent to a printer that 'draws' each layer by extruding plastic through a hot nozzle.
There are a lot of different materials available now but the two most common are ABS (LEGO plastic) and PLA (biodegradable plastic) which is what Charlesworth Dynamics uses.
While the 3D prints aren't hazardous, they are not food, dishwasher or microwave safe.
They are very strong, but will break just like any plastic item if abused.
3D prints are very strong if printed properly but will break just like any plastic item if abused. Since the object is printed in layers, they will have a slightly ridged texture to them unlike a injection molded object. There is usually a 'zipper' which is a slight vertical seam that indicates where each new layer starts. They may have slight defects or blemishes and the bottom which adheres to the print bed may have some discoloration. Kit pieces may need minor clean up or trimming to fit together. This is typical of most 3D prints.
Yes, you can sand and paint 3D prints like a normal plastic model. You can even use products like Bondo Glazing and Spotting putty to minimize and smooth the 3D printed texture. Make sure to use a plastic-friendly paint.
I include a link for assembly instructions with your shipping notification, but here's a link for all assembly guides:

Please don't hesitate to contact me with any questions or recommendations.
On occasion I will also build items out of 'real' parts and hardware - typically I use vintage Film & TV equipment parts. I have made lamps out of old lenses and jewelry out of old camera parts. Keep in mind that these are all used parts and will show their wear and tear and age - it's part of their charm.

Ghost Trap Hose Deluxe



  • Handmade item
  • Made to order
  • Ships worldwide from United States
  • Feedback: 134 reviews
  • Favorited by: 56 people