Whoa! You can't favorite your own shop.

Whoa! You can't buy your own item.

Whoa! You can't favorite your own item.

Whoa! You can't add your own item to a list.

Add this item to a treasury!

Close
You don't have any treasuries yet. Enter a title below to create one.
Close

This item has been added.

View your treasury.

Like this item?

Add it to your favorites to revisit it later.
If you're scratch building your own Ghost Trap Pedal here's a series of tubes to finish it.

Movie accurate parts include:

- Approx. 7" of 20 pin 28AWG ribbon cable and cable ties used as handle
- Approx. 6" each of 5/32" OD red and yellow pneumatic tubing
- Approx. 2" rigid 2"OD - 1.75" ID hose used for pedal bellows

If you are building a Trap Pedal from my 3D printing files, which you can get here: http://www.thingiverse.com/thing:1394639
then you may want to get the Trap Pedal Standard Hardware Kit, which includes all of these parts plus all the nuts and bolts, relay, etc you need for a complete trap:

Trap Pedal Standard Hardware Kit: http://etsy.me/1QFhDis

Fully assembled Pedal shown for demonstration only and is not included.

Frequently asked questions about CharlesworthDynamics

3D printed objects are made by 'slicing' a digital model into many thin layers. These slices are sent to a printer that 'draws' each layer by extruding plastic through a hot nozzle.
There are a lot of different materials available now but the two most common are ABS (LEGO plastic) and PLA (biodegradable plastic) which is what Charlesworth Dynamics uses.
While the 3D prints aren't hazardous, they are not food, dishwasher or microwave safe.
They are very strong, but will break just like any plastic item if abused.
3D prints are very strong if printed properly but will break just like any plastic item if abused. Since the object is printed in layers, they will have a slightly ridged texture to them unlike a injection molded object. There is usually a 'zipper' which is a slight vertical seam that indicates where each new layer starts. They may have slight defects or blemishes and the bottom which adheres to the print bed may have some discoloration. Kit pieces may need minor clean up or trimming to fit together. This is typical of most 3D prints.
Yes, you can sand and paint 3D prints like a normal plastic model. You can even use products like Bondo Glazing and Spotting putty to minimize and smooth the 3D printed texture. Make sure to use a plastic-friendly paint.
I include a link for assembly instructions with your shipping notification, but here's a link for all assembly guides:
charlesworth-dynamics.com/2013/08/instructions.html

Please don't hesitate to contact me with any questions or recommendations.
On occasion I will also build items out of 'real' parts and hardware - typically I use vintage Film & TV equipment parts. I have made lamps out of old lenses and jewelry out of old camera parts. Keep in mind that these are all used parts and will show their wear and tear and age - it's part of their charm.

Trap Pedal DIY Parts

$12.00

Overview

  • Handmade Supply
  • Made to order
  • Ships worldwide from United States
  • Feedback: 134 reviews
  • Favorited by: 26 people