Retro 3D Printed Case for ESP32 2.8" ILI9341 Touchscreen Display - CYD (Cheap Yellow Display) Ticker Enclosure | PETG-GF Handmade

Hey there, makers and tech enthusiasts! 🌟

Looking for a stylish, retro case to house your DIY ESP32 Cheap Yellow Display project? This custom 3D printed enclosure is designed specifically for the CYD Ticker project (from Tickertronix on GitHub), giving your ESP32-2432S028R setup a vintage-inspired look. It's perfect for displaying real-time data on a 320x240 touchscreen in a sleek, desk-friendly stand.

Important Note: This listing is for the 3D printed enclosure kit ONLY. It does not include the ESP32 board, firmware, electronic components, or any software. You'll need to source and install those yourself (check the GitHub repo for details on building the full project, including a Raspberry Pi Hub for data). This enclosure is designed for the (ESP32-2432S028R) 2.8" touchscreen display aka the Cheap Yellow Display.


What Makes This Special?

Retro Design Vibes: Think old-school ticker tape machines with a modern twist – bezel, angled stand, and all. Perfect for desk display without blocking your view.
Tough Build: Printed in premium PETG-GF (PETG reinforced with glass fiber) for extra strength and durability. No flimsy plastic here!
Secure Fit: Uses brass heat-set inserts and M2 x 20 socket head cap screws for a rock-solid assembly. (Pro tip: Grab an Allen wrench for the screws – not included.)
Cable-Friendly: USB-C access for power/programming.
SD Card Accommodation: Recessed portion in the case allows the microSD card to fit securely on the board (no external access slot).
CYD Ticker Ready: Designed to fit the ESP32-2432S028R with ILI9341 touchscreen – houses your board securely while leaving USB-C access for power/programming.
Details & Specs:

Dimensions (Approx): Frame fits the 320x240 display area; holder for angled desk setup; back cover attaches securely with screws.
Material: PETG-GF – strong, heat-resistant, and ready for everyday use.
Compatibility: Designed for ESP32-2432S028R with ILI9341 touchscreen (board not included).
Assembly Time: Just 5-10 minutes with an Allen wrench.
Weight: (200-300g).

What's in the Box:

Pre-printed enclosure kit (3 pieces: Frame, Holder, Back Cover)
Brass heat-set inserts (already installed)
M2 x 20 socket head cap screws (4x)


How to Put It Together:

Pop your ESP32 board into the frame (line up the recessed bits).
Screw the back cover on hand tight using the M2 screws and Allen wrench.
Slot the whole thing into the angled holder.
Power up with your USB-C cable!
This is a handmade item, so slight variations in print finish are part of the charm. If you need custom colors or tweaks, just message me – I love collaborating!