Avengers The Eras Tour DTF Transfers, Marvel Super Heroes Heat Press Transfers, Captain America, Ironman Tee, The Hulk, Spider-Man

Avengers The Eras Tour DTF Transfers, Marvel Super Heroes Heat Press Transfers, Captain America, Ironman Tee, The Hulk, Spider-Man

Each design is measured on its longest side to ensure a proportional fit. For two sided prints, your size selection will be applied to the back and front design will be sized accordingly. For sweatshirts or hoodies, you can order 1-2 inches larger. Please note, these measurements are approximate and may vary slightly. The dimension provided corresponds to the largest part of the design, meaning it could be applied based on the height or width, whichever is greater.

💖DTF Transfer Application Instructions💖
💖Preparation: Preheat the garment for 15 seconds to eliminate any moisture. Allow the garment to cool before proceeding.
💖Placement: Position the transfer with the white side facing down and the image up.
💖Heat Press: Apply the transfer at 325°F for 15 seconds under firm pressure.
💖Cooling: After pressing, remove the garment and wait until it's completely cooled before peeling.
💖Peeling: Peel the transfer cold.
💖Final Press: Place parchment paper over the design and press again for 15 seconds. Alternatives like Teflon sheets or butcher paper are also suitable.

💖Care Instructions💖
💖Ensure longevity and vibrancy of your printed garment by turning it inside out before machine washing in cold water.
💖Avoid bleach and fabric softeners.
💖Do not iron or dry clean.
💖Tumble dry on low.
💖Direct ironing on the design is not recommended.

💖💖Important Note: If the image does not fully transfer, repress with the parchment paper in place, let it cool, and then try peeling again. This process requires a heat press capable of delivering 60PSI of pressure.

💖💖Remember, the success of a DTF transfer can depend on the specific equipment and materials used. Follow these guidelines to achieve the best results and make your designs stand out.