Close

Whoa! You can't favorite your own shop.

Whoa! You can't buy your own item.

Whoa! You can't favorite own item.

Whoa! You can't add your own item to a list.

Add this item to a treasury!

Close
You don't have any treasuries yet. Enter a title below to create one.
Close

This item has been added.

View your treasury.
KIT TO BUILD - Noise Hero - Lofi Electronic Musical Instrument Noise Maker

Sorry, this item sold. You may also like:

Like this item?

Add it to your favorites to revisit it later.
PLEASE NOTE: The noise hero kit is quite complex and uses a strip-board circuit board, it should be considered only for people experienced in soldering and building.

Please copy and past this link to hear what the Noise Hero can do: http://www.youtube.com/watch?v=gd9QBBueroA

and some more examples here: http://www.youtube.com/watch?v=LxrgBa1ZBO8

This item is a kit to build your very own Noise Hero including all the components, a CDR of instructions, a piece of stripboard, battery holder, knobs, wooden base and aluminium face plates.

You will need the following tools to build the Noise Hero circuit:

A drill, a 4mm drill bit, a 1.5mm drill bit, a fine tipped soldering iron, some solder, side cutters, some wire wool or fine sand paper and wire strippers. A helping hands type device will help you keep the circuit from moving around. Also a wide tipped soldering iron is useful for getting rid of any solder bridges between track of strip board if your soldering is less than perfect.


You will need the following extra tools for mounting the circuit onto its base:

A dot punch or sharp nail/screw, a 9mm drill bit, a13mm drill bit, a metal file, some plyers and a small pozidrive screw driver.

Here's some information about what the noise hero can do:



Noise hero is a little 4093 based electronic noise maker. Its great for making sound effects and silly noises.

It is controlled by 5 knobs, 8 switches and one push button.

It has 3 oscillators (Yellow, Green and Blue knobs). Osc 1 produces audio frequency ranges whilst osc 2 and 3 produce LFO and audio frequencies.

Osc 1 goes to the output through a simple passive filter (Red knob) while osc 3 can be switched to the output but bypasses the filter.

Osc 3 modulates osc 1's pitch by the amount set by the orange knob. This modulation can be shaped by 2 shapers which can be switched on and off. Osc 3 can also gate osc 2.

Osc 2 can gate osc 1 and passes through an inverter after which it can gate osc 3.

There is also a push button to trigger the unit (actually a power button), a switch to lock the power on, a power led indicator and a battery cap switch which lets the unit run for a short time after power off for springy type noises.

A certain configuration can even produce sounds that stop after a time determined by osc 3 which is good for maker sound effects.

The knobs all go backward. This is because I'm using logarithmic knobs which make the oscillators easier to control when wired up the wrong way round.

The Noise Hero is powered by a single 9v battery (not supplied). It requires external amplification via an amp or soundcard to be heard.

Its mounted on a reclaimed hardwood and aluminium base. The type of hardwood may vary and there may be surface marks to the aluminium. It is also supplied with an instruction CDR.
Its dimensions are: 14cm x 8cm x 4.5cm or 5.5" x 3.25" x 1.75"

KIT TO BUILD - Noise Hero - Lofi Electronic Musical Instrument Noise Maker

Overview

  • Handmade Supply
  • Materials: wood, aluminium, electronics, cdr
  • Feedback: 106 reviews
  • Ships worldwide from Boston, United Kingdom
157