Ironside Customs handlebar item holder for Can-Am RYKER 3D printed hard plastic for helmet

• 4.9 item average 67 reviews
Made by IronsideCustomShop
• Materials: PETG, PLA, PLA plus, plastic

3D printed PETG (Hard plastic) handlebar item holder for the Can-am Ryker all models with factory handlebar. The holder fits in between the mirror and the handlebar.

please create Etsy account to receive preview of product prior to sending.

Some of my products I do use PLA+ which has a higher heating point and is tougher than regular PLA but is still weaker than PETG! Be gentle with them, they are PLASTIC. (I have temporarily removed the PLA caps due to inconsistencies in the filament, I will take special requests, so please message me if there is a color that you would like that isn't listed) Ironside Customs is not responsible for any damage caused by installation or removal of our products.

A lot of 3d prints are with weaker PLA. I have printed these parts using PETG and PLA+ which is stronger and has a higher heat tolerance.

PETG handles weather and sun far better than regular PLA.

Please let me know if you are interested in another color

Single Fat holder- 3 5/8" X 1 5/8" X 1"
0r 9mm x 4.5mm x 2.5mm
Hole is wider than the two below and thinner - may work on other vehicles
4.40 mm flat 26.77 - 26.99 hole tapers on front and back

Double Tall Ryker holder- 4 1/2" X 1 5/8" X 3/8"
11mm x 4mm x 1mm
Hole is snug around Ryker mirror - you can shave with razor if needed - I left mine snug and I had no issues installing
8.15 mm flat - 23 mm back of hole size - slants to get larger on the front 27 mm

Double Short Ryker holder- 3 1/8" X 1 5/8" X 3/8"
8mm x 4mm x 1mm
8.15mm flat - 23 mm back of hole size - slants to get larger on the front 27 mm

Handle from James Leenan on https://www.thingiverse.com