Close

Whoa! You can't favorite your own shop.

Whoa! You can't buy your own item.

Whoa! You can't favorite own item.

Whoa! You can't add your own item to a list.

Add this item to a treasury!

Close
You don't have any treasuries yet. Enter a title below to create one.
Close

This item has been added.

View your treasury.

Like this item?

Add it to your favorites to revisit it later.
This hand forged key or jewelry rack has been hammered all around to give it that warm hand made traditional look.

5 hooks were formed and attached to the rack with decorative copper rivets.
The rivets are hammered into place from behind.(The traditional way).
I then welded each hook to the rack(always from the back side, to keep everything clean). This gives it extra strenght.

The rack is signed with my logo "Naz" while the metal is hot so it gives a deep crisp impression.


For cleaning, I use the wire brush followed by a light sand paper. This highlights the hammer marks. I heat everything up again and brush on a traditional blacksmith anti-corrosion treatment for inside ironwork applied at a low heat.(This treatment contains beeswax and boiled linseed oil).I really like this finish as it leaves the bare metal to be seen with it's highlights and gives an excellent protection for inside ironwork.

Included are 2 decorative wood screws that match the ironwork.

Made to last long.

Total lenght is 12".

PS : If the keychains are what gets your attention, visit my daughter's Etsy shop at :
http://www.etsy.com/shop/DazOriginals

Thanks for visiting my shop !

Naz
Claude Nazair

KEY or JEWELRY Rack (5 hooks) Hand Forged and signed by a BLACKSMITH

Overview

16