In 16 carts
Onefinity Router Light ring 65mm and 80mm
This is a physical product The digital files will be listed later in the next month!!
Stop the struggle of seeing where exactly the bit is in relation to your material!!
Here is the 65mm router and 80mm spindle light. Super easy to install!!
It comes with a fully threaded replacement bolt for the router clamp. Just pop off the bottom bolt that holds the router and slide the light onto your router and hand tighten the light onto your Onefinity.
This item comes with everything put together and ready for installation.
Cord length is approximately 10 feet and comes with a 110v standard American plug
Here is a link to a beta testers review: https://forum.onefinitycnc.com/t/another-bright-idea-from-rowdyroman-led-router-light/5192
As suggested on the above review this can be installed into a relay which would allow the light to turn off when the project is complete
IMPORTANT NOTE: THE LIGHT MOUNT USES A RIVET NUT WHICH EXPANDS IN THE 3D PRINTED PART. DO NOT USE A DRILL TO TIGHTEN THE LIGHT MOUNT TO THE ONEFINITY!!!! USE THE ALLEN KEY TO INSTALL. YOU CAN STILL TIGHTEN IT PRETTY HARD BUT BEWARE THAT IF YOU EXPAND THE RIVET NUT TOO MUCH YOU WILL CRACK THE 3D PRINTED PART. GOOD PRACTICE IS TO USE THE LONG END OF THE ALLEN KEY INSERTED INTO THE BOLT AND THE SHORT END OF THE ALLEN KEY AS YOUR TORQUE
There was a problem calculating your shipping. Please try again.
This shop had returning customers within the past 6 months.
1,227 reviews5 out of 5 stars
Wow! What a cool addition to my CNC. Easily installs, no need for directions, it's a no brained if you like to check closely on the progress of your project. Single screw attachment. Quality construction with nice long cable protection and solid plug-in. Connects easily along my vacuum hose using clips. Glad that I got this one, it's bright!!
This is the greatest! Even though my shop is well lit, I found it hard to see what the milling bit was doing. Now it's lit up really well. I found mine (the 65mm size) easy to install and appreciate the long power cord. Highly recommended.
Haven't even hooked up controller to run my first piece but already love the fact that I can see what's happening at the router level. Only wish the plug was a bit smaller so I didn't have to drill a bigger hole in table top for cord management. Small issue and a definite buy for anyone interested in a very nice upgrade.
This thing is great .it's easy to install and the light is really bright. So glad I got this for my cnc
Photos from reviews