You will receive 5 glue syringe applicators each measuring 3 ml.

You will receive 5 white tips as pictured.

Hole measurement as follows:

.045"-.047"

1.14-1.19mm

Great for applying glue exactly where you need it. This method will save you a lot of time on any project from construction to crafts.

*Directions for use. Pull the plunger rod out of the barrel. Squeeze glue up into the barrel. Replace the plunger and at the same time you are also pushing glue up toward the tip. Push until the product reaches close to the tip without overflowing and twist on the white tip.

Tip: Have a paper towel in hand for pinching and holding the end so that glue doesn't leak out during your project.

Please, don't hesitate to ask for further assistance with this product.

p.s. to answer a question I receive quite often.. "Are the syringes reusable?" Answer: Generally these are one-time use applicators; however, (from a personal perspective) with proper care I am able to get between 1-3 uses from each. I prefer not to waste product therefore I estimate how much glue I will need. After I'm done with the applicator I will squeeze out the remaining glue (which there should not be much glue left if any in the barrel. I twist off the tip, pull out the rod and grab a paperclip. I simply extend the paperclip and use it to remove the excess glue from the white tip, the barrel and the black stopper (which determines the life of the syringe).. How? As long as the black stopper keeps its lubrication that will allow the rod to slide easily back and forth for application. The natural oils from my fingertips will dull it which is why I use a paperclip. I reassemble for next use. I hope this helps. Again, if you have any further questions, please do not hesitate to ask.



Thanks for looking!