Flash3DPrint

Made my overpriced SecretLab chair almost good. Not sure if my upper torso is shorter than your average person's, haven't had this issue with other chairs so it's never been something I've had to think about but these armrests are way too high by default. Even with this kit they're just barely low enough, I'd still like it a little lower. That isn't the fault of this kit, however. If they were lowered even more they would be stopped by the paddles for adjusting chair height and tilt since they sit just below. The kit itself is 5/5. I can't find any complaints. Now I can have the armrests attached to the chair which I couldn't before due to the height.

Ideal. My chair was always too high and had to do all kinds of stupid fixes to be comfy. These extensions are easy to apply and does what it should. Though, if you adjust your chair a lot, care if you use both pieces. The paddles get very close to the screws etc and get a little harder to reach, but for me a perfect trade in

Great product and exactly what i needed to lower the arm height on my chair so it would fit under the desk as well as make the arms usable as they were too high normally.

Absolutely perfect. Solved the problem for me straight away. Fast shipping as well. Very happy.

Overall the 3D printed portion of this does a very good job, gets the arms to a more usable height and has enough surface area to distributed the load properly. The bolts that it came with however are very questionable. Mine were a counter sunk head. Not like the ones in the photo which use a driver head. Which is probably the only head on a 8m bolt you probably should use for this application. Any other flat head bolt would distribute the load properly and probably won't come lose over time like a counter sunk bolt will. I ended up not using them and just buying 6 8m 1.25 50mm bolts with a driver head similar to the original bolts on the chair and threw on some 8m washers which also would have been nice.

Great kit with 3D printed (but good quality!) spacers and screws, reasonable price, mounting it under my Secretlab chair's armrests was extremely easy and now the armrests are at a comfortable height where they fit under the desk when the chair is rolled up to it. Full recommend!

Matches my expectation and is a great improvement for my chair.

I've had a Secret Lab Evo Titan 2022 for a while now and the arms would not lower to match my extendable keyboard. This gave me shoulder pain from the downslope angle while typing. This perfectly engineered item fixed my problem! I highly recommend this kit for anyone experiencing shoulder pain and/or chair arms too high for your computer desk.

This kit finally made the armrest useable. I had to remove the armrest because of how uncomfortable they were. Thank you!

The item arrived very quickly considering it came from Germany. I have been having awful shoulder and neck pain down one side with my SecretLabs chair, as the arm rests even on the lowest setting were too high. These spacers have made such an improvement and I'm not in pain anymore.