EVOLENDesigns

This set Looks very good. Here is some feedback. Had a few complications when putting it on. The top of the pick guard where the top screw is was very thin and cracked separating from the pick guard. The spot where the two covers come together was too tight so i had to shave it slightly to fit. The lower cover's screw holes didn't line up exactly. It was a little off so the bottom left screw hole cracked. And finally the top right screw area on the lower cover was thin and cracked during installation. Everything looks fine and is holding but due to the brittle nature of the PLA and the fact its 3d printed makes it a bit of a challenge getting it exactly right. The 3 hole truss rod cover worked perfectly. And no issues with the switch cover. customer service is top notch and they are replacing the pic guard that cracked.

Great customer service and response.

Was great fit appreciated the extra pick gaurd thank and have a great new year