Pattern：1 5/8 * 1 1/4" (40 * 33 mm)
25mm thick acrylic block and engraving 3mm deep of the pattern.

This thick, ultra-clear acrylic stamp handle is perfect for precise stamping, easy to line up straight onto the project, and easy to see through, hold, pull out, and get a nice clean imprint. The acrylic block is flat which allows the user to apply even pressure on each side of the stamp with hands, or stamp a good clean smack with a rubber mallet if needed.
Soap stamping:
1.) Make sure your stamp is clean, use a toothbrush to scrub out any soap bits.
2.) Place the stamp on the soap then lightly tap the stamp with a "Rubber Hammer" 3 to 5 times. A Rubber Hammer works great for stamping, it gives you a nice and clean impression and you can always put the stamp right back to the mark impressed on the surface to adjust the deep or uneven; make it prettier if you are not happy with the result. You don't need to stamp too deep, about 1/8 inch is plenty. Practice several times to get comfortable with the process.
3.) After use, clean the stamps using a brush and water. Dry thoroughly before storing.
PS: Depending upon the formulation of your soap, the soap may be ready for stamping after it's cut 3-8 hours (ex: 80% coconut oil). Softer soaps may require a few days of aging. The soap should not stick to the stamp; if it does, the soap needs to harden a bit. In contrast, the soap should not break after stamping, if it does, the soap is already too hard, cut the surface off (3mm) and stamp again.

Check out our shop：
http://www.etsy.com/shop/soaprepublic
Shipping, Payment and more information：
http://www.etsy.com/shop/soaprepublic/policy