Finest blending edges available!

Wizafir latex prosthetics will give you the look of fantasy and science fiction creatures along with whatever your imagination can dream up.

Pictured above is how I used them with our Merfolk ears for a red and gold dradon look.

- Hollow cast latex
- Fine blending edges
- Glues to skin for strong, nearly invisible hold.

Note: The prosthetic may have small bubbles or imperfections from the molding process. If you feel that your prosthetic is not the quality you expected please let us know before leaving feedback so we can determine if a replacement or refund is appropriate.

Product may have cornstarch on it from the molding process

You will also need to purchase the following:

Prosthetic adhesive (spirit gum, prosaide, etc.)
and
Adhesive remover
Available online or at a costume store that does rentals and clown supplies

Makeup

Face Powder

To apply: Clean skin with a non-greasy astringent and dry. Position the prosthetic over your ear and determine proper placement. Apply a thin layer of adhesive to the underside of the prosthetic piece and to the skin where the piece will be adhered. After the adhesive has dried, press the piece down firmly, especially around the edges.

Makeup application: After your prosthesis is firmly adhered, you can apply a sealer such as PAX paint or prosaide to the piece and a little over the surrounding skin, then powder. You may then apply a makeup to blend, or skip the sealer and use rubber mask greasepaint to cover the piece and blend.

Removal: Using a Q-tip, apply a small amount of remover along the edge of the piece. Slowly lift an edge and start applying remover underneath the piece. Keep working it under until the entire piece is free.

Storage: After the piece has dried completely, powder the underside of the prosthetic where the adhesive was. Seal in a plastic bag and store in a cool, dry area out of direct sunlight.