Eye glass topper blanks are 3D printed in a few standard colours which are black, white or grey. They now use square magnets that are as strong as the original toppers.

Note - I have not yet updated any of the image files to display a topper with the square magnets

Toppers are printed flat. If they need to be curved to better fit your frames you can heat them up with a blow dryer on low for 10 to 15 seconds. Now try placing them on your frames and if they need more of a curve try heating them again for another 10 to 15 seconds again. Over heating your topper can melt them. Do not use a heat gun! A heat gun is too hot and will damage your topper.

3D prints may have minor flaws or extrusion lines that are visible. We print your toppers so that these flaws, if they happen, will be on the inside. This means that you will never see them when they are worn.

Most of our toppers can be worn "as is" but they are intended to be decorated. You can use paints, nail polish, spray paint or you can even glue materials to the toppers to make them yours and unique.

These toppers include round magnets to attach to your frames. Magnets are attached with super glue. We do have an alternate product with glue dots if that is what you prefer which also has a lower price point.

The following styles are currently available:
Casper, Cedro, Drew, Ella, Finley, Harper, Jesse, Kirby, Larkin, Murphy, Otero, Otis, Quinn, Reese, Serra, Soto, Twain, Wanda

US and International shipping are available. Since there is a product inside the envelope, it must be declared and we are not permitted to ship at envelope rates.