BLEMISHED PRODUCT - THE BRACKET HAS MINOR SURFACE DEFECTS SHOWN ON THE UNDERSIDE OF THE PRODUCT.
PRODUCT IS 100% FUNTIONAL AND WORKS GREAT AND AS IT SHOULD! IT'S PURELY DISCOUNTED BECAUSE OF THE SURFACE FINISH ON THE BRACKETS UNDERSIDE.
(ANTLERS NOT INCLUDED)
Original Price is $169
MOUNT MOOSE, ELK, OR RED STAG ANTLERS WITH EASE!
DIY TAXIDERMY
Designed for a pair of BIG GAME antlers, the patent pending RH2 XL is manufactured from high-strength aluminum that has been anodized in a matte black finish. The two ball-joint assemblies rotate on all axes allowing your antlers to be displayed in virtually any position. After you find that perfect position, simply tighten the top knurled cap. Your trophy orientation will remain intact and you’ll be able to remove your antlers at any time, show them off, and then dock them back in place. Our clean minimal aesthetic ensures all of the focus will be on your trophy.
Note: There is a set screw located on the bottom of the ball joint that can be tightened to ensure maximum security; this feature is optional and not necessary.
Package includes:
- Fully assembled RH2 XL
- Installation instructions
- XL Antler inserts (x2)
- 1/2" Brad point drill bit
- 3/16” hex wrench
- Mounting screws (x2)
Installation Instructions
1) Mount the RH2 XL bracket to a wall or desired location.
2) Use the included 1/2" bit to drill into the base of the antler. (approximately 1 inch in depth)
3) Place the provided insert into the base of the antler.
4) Place each antler onto the hex stem (attached to the ball).
5) Adjust antler positioning by rotating the ball and tightening the top XL Knurled Cap.
6) Step back and enjoy your trophy, knowing that you can remove the antlers at any time.