Mount any Action camera to the back of the DJI FPV drone using the DJI FPV Camera Backpack Mount. This 3D printed TPU mount clips on to the battery protecting the battery too. This is a more rigid TPU to eliminate vibrations yet still give a good amount of protection for your battery.
This completely original idea will get you filming like a backward flying god (at least make it look like you do).

Includes the 3D Printed mount, nut, bolt and 3mm hex wrench. This setup with the slim nut and bolt eliminates needing to use a huge GoPro thumb screw that just adds more weight.

INSTALLATION INSTRUCTIONS (REFER TO IMAGES):

1. Insert the battery plug into slot on the mount.
2. Hook the bottom of the mount over the feet on the battery.
3. Secure the top of the mount over the top of the battery
4. Firmly plug in the battery into the drone, MAKE SURE THERE ARE NO GAPS. It will take more force than usual to install the battery plug, this is normal.
5. Install any Action camera into the mounting point on the Camera Backpack and secure with the included nut, bolt and Allen wrench.

See the complete installation and flight video here: https://youtu.be/yKAcyCcalwg

The drone and camera shown in the photos are not included, this listing is for the mount, bolt, nut and wrench only.

**Disclaimer - Aerial-Pixel will not be held responsible for the use and/or misuse of this product. Any damages to equipment or bodily damage are solely the responsibility of the purchaser.**