3d printed 1:12 scale MAC-11 long clip

Modeled by figuregear.com

All items are made and painted by hand. There will be differences and imperfections in each piece. I strive to make quality items. Please understand that these are more fragile than a manufactured item. Please handle them with care.

NO FIGURES INCLUDED. ONLY THE WEAPON IN THE LISTING.

Weapons, heads, shields, and jet packs are made with resin that is slightly flexible.

Wearable items are made with Siraya Tenascious 80/20 mix to provide strength and flexibility. If you purchased pre-painted items, the paint may cause the item to be more rigid. You may need to heat items and shape them to your liking (Hot water may be the safest method). Most vests will need this to fit properly and fasten onto a figure. Once in place, I recommend gluing the connectors.

All heads will need to be fit to your chosen body. Dremeling, putty, etc will be needed to ensure a proper fit. I use a method that utilizes hot glue. Use petroleum jelly on the neck peg. Fill the head hole with enough glue to push the peg into the head and some of the glue to squeeze around the neck ball. As it dries, continue to move the neck peg so it will not bind in the hole.

Thank you so much for considering a purchase!
All hand-painted items present the chance of paint rub. Either the paint off the item or the paint off the item onto the figure. This isn't very common with the finish I use, but it has happened. Please handle the items with care. If placing a vest onto a figure and it needs to be shaped first, please warm it slowly with a hair dryer. Thank you!