Marine Grade Vinyl Tacoma TRD Off Road Wheel blackout overlays 3rd gen

Note: Make sure your wheels are the same as the ones in the pictures here.
Your order will include enough pieces to do FIVE WHEELS (just in case you mess up).
Center Cap Stickers INCLUDED :) Instructions below.

I make these from premium Marine Grade 951 CAST VINYL.
THIS IS IMPORTANT. Cast vinyl is superior to (other sellers economy 651) calendared vinyl. Cast vinyl is more expensive, more conformable, longer lasting, more dimensionally stable (it doesn't shrink like calendared vinyl will), and it's more stable under temperature extremes.

They are oversized by about 1/8” all the way around and each of the spokes are in manageable sized pieces. This makes installing them much more forgiving and easier. I went through several versions of this design on my personal truck. This is the best and easiest version. You don't have to trim them at all. They look great as is.

I would love to see a before and after picture of your truck when it’s done. 👍

Don’t worry if you get a few small bubbles they will likely disappear after a week or two.
Creases will get smaller but a crease will not go away. Try not to crease them.

Time lapse of install- https://www.facebook.com/FlatSixGraphics/videos/322820188465314/

If you have trouble removing the vinyl from the backing paper use a knife edge to lift them, it works great.

Always...
Make sure your wheels and hands are clean before installation! Any dirt or debris will affect the look and life of the decal. We recommend using simple green and a clean wheel that is wiped down with rubbing alcohol (isopropyl alcohol) before applying your decals. The ONLY reason these will fail is if YOU fail to clean your wheels good enough and follow the directions here so please read them carefully and ask questions if you have them.
Remember…As with any mod, it is important to do your own research to find the best application method for YOU! These are only our recommendations. What may work for you may not work for everyone and vice versa!

Dry Application Method:
Make sure your wheel is clean, preferably using rubbing alcohol/isopropyl alcohol.
Remove the decal from the white backing paper. Use a knife edge to lift it if its being stubborn or tearing the paper.
Once your decal is on, make sure you rub over every angle, side, corner, etc.to assure it has all adhered to your wheel.

Wet Application Method:
First, clean your hands and the application area with rubbing alcohol/isopropyl alcohol.
Take a small, clean spray bottle and fill it up with water and a few drops of baby soap.
Very lightly spray water on the sticky side of the decal AND on the cleaned, application surface.
Slowly place the decal on the application area following behind with a soft squeegee to make sure all of the water/bubbles get out from under the decal. You can then wipe off excess water after you are done.
Most importantly, make sure you run over every edge so that the vinyl is fully adhered to your wheel on every corner, angle, side...etc…
Please contact us directly if you have any questions or concerns.

Note: Do NOT install these when it’s cold. Install between 60f-80f degrees. Do Not install in direct sunlight (it makes it more difficult).