24x12x3‘’ 24x18x3‘ 18inch 16 inch Reusble NO-SEAL Epoxy Resin Reusable Form - HDPE Forms for Makers - Forming Molds Table Mold Board Forms


We accept all sizes of customization， If you need customization, please leave us a message .

Size : ❥ All the size are inside size (the finished size )
All size with thick 8mm wall ;

❥❥ HDPE detachable mold for better demoulding , please visit this link:

https://www.etsy.com/hk-en/listing/1362938252/custom-10-to-18-24-inch-epoxy-resin?ref=listing_published_alert

❥❥ These are HDPE molds , If you like silicone mold, please click this link :

https://www.etsy.com/hk-en/listing/1327356604/large-24-inch-18inch-16-inch-silicone?ref=listings_manager_grid&variation0=3001722514


It is a bit difficult to demold from the mold than silicone molds , so you need to be more time and more patient.

❥❥❥ ❥❥❥ : To remove the set and dry epoxy piece from the mold, need push on the inside of the upper side walls of the mold with your hands (or use a rubber mallet) to detach the walls of the mold from your piece. Then turn the mold upside down and gently hit the bottom side with a rubber mallet until the piece falls out onto your work surface.

❥❥❥ ❥❥❥ : To make demolding even easier, we recommend using a mold release spray, available on other shops. This is definitely very NECESSARY and will reduce the efforts required to demold your work from these molds.

!!!!! Note : our molds are soldered and here are the traces of welding. that's inevitable . and the resin product you made needs to be polished with 4 corners lines, Make it rounded, not straight . If you mind, don't purchase .

Great reusable forms to craft river tables, etc.

This no seal form is welded together to create a tight seal that never requires sealing.
Simply turn the form over once it’s cured and tap the back with a mallet and watch your creation pop out of the mold.
These are handmade and not acceptable for returns or cancellation.