Whether you're planning on hanging a pot of flowers, or perhaps a a set of wind chimes, these hooks add a rustic charm to any front porch or backyard patio.

(Due to high demand it may take me between two to four weeks to get these finished up and shipped out, if you need them sooner let me know and we can make arrangements to try and expedite them, thank you. Tim)

I can make these in several different sizes, from 2" to 8", but if you need a different size than the ones I have listed, just send me a message, and I'll customize it to fit your needs.
the "length" refers to the distance from the back of the hanger to the "hanging point" of the hook, so the total length will be an additional 1 inch or so longer, to accommodate the decorative finial.

Hand forged from steel, these are meant to last, and can hold a surprising amount of weight, I always strive to design my hooks to maximize strength while maintaining a lighter, and more airy style, so I think you will find these are much heavier duty than they appear, this particular design will easily accommodate over 30 pounds of weight!

All of my items are hand forged by me when you order them, so it will take me 1 to 2 weeks to get your order shipped out, and since each item is custom made after you place the order, be sure to let me know if there are any customizations or changes you want included with your items when you place your order.

Please note that since each item is hand forged from scratch, the appearance may vary from piece to piece.

All of my hooks are made from low carbon steel, which has the possibility of rusting, but I have a couple of different finish options in order to protect your items for years of use. The traditional blacksmiths finish is to apply a layer of beeswax on the metal when it's still hot which creates a tough water resistant matte finish that will work very well on all indoor items, or in protected outdoor areas with care. However for higher moisture environments and for direct sun outdoor exposure, I can apply a heavy duty outdoor polyurethane coating, which is much more rust resistant.
Remember though, that any finish is going to wear off eventually, so if you do start noticing rust developing then you can buff it out with steel wool or a wire brush, and then apply a paste wax to renew the finish. And be sure to let me know if you have any questions or concerns about the finish of your hooks, I'm always glad to answer any questions you have.


***

Be sure to check out the rest of our shop, and our growing list of products. If you like what you see, but would like to add a bit more of a personal touch, be sure to give us a ring! We can do just about anything as far as custom orders, and at no additional cost. Just send us a message, and we'll get the conversation started!
https://www.facebook.com/AngryParrotForge