1.5" Handmade Oxblood Water Buffalo Leather Belt

If you require a size that isn't listed, reach out to us as we custom cut each belt.

SIZING TIPS: 
1) We recommend you measure a belt you wear from the fold around the buckle to the hole you use the most, please see attached photo.  
( DO NOT measure the entire length of your belt including the buckle.) 

2) Go up 2 sizes from jean waist measurement to belt size ie. size 36 pant waist is a 38 belt.  (Please note: We have had good luck with this, but it doesn't always work due to different pant brands having different waist sizing, but we always do exchanges if size is wrong)

3) Measure your waist with your pants on through your belt loops, then subtract 1" for the buckle length.  A measured waist 36 would be a 35 belt, this is because I measure my belts from the fold of the leather at the buckle to the middle hole.  

Buckles can be removed by undoing the 2 Chicago screws. We recommend using a piece of scotch tape with your finger pressed on the front of the screw holding it firm and remove the back by twisting with a flathead screwdriver.

We punch 6 holes so your middle 2 holes are before & after dinner 😊 Request 5 if you prefer that.

This Oxblood Distressed Water Buffalo firm leather has a matte finish which shows distressing as the buckle slides over the leather or the leather bends. This is aniline leather will show imperfections from the animals life. Natural leathers will vary in colouring depends on the hides.   The leather is 8/9 oz or 4mm thick.

*ALLERGY INFO* 
The roller buckles, stainless steel are the only buckles we have without nickel!! 
All *FREE SHIPPING* is sent regular post, please purchase faster postage at the time of checkout.