!!!NEW - Updated design to allow slightly larger cups. 3 spring loaded paws will hold smaller cups or cans in place securely.

This is a 3d printed version of my other popular cup holder (https://www.etsy.com/listing/1493781795/cup-holder-for-porsche-996986?click_key=6a25d9a77199b56cd23cc8bd22217142ded9674d%3A1493781795&click_sum=0fecf6f2&ref=shop_home_active_5&crt=1&sts=1) it is less than half price yet providing similar functionality. With that in mind expect to see slight layer lines on the surface, and occasional small imperfection - these are normal and expected with FDM printing.

RENNDITION cup holder consist of two parts:
- Base - which replaces the side trim in center console. It uses original mounting points (4 tabs held by metal clips) which keep it strongly secured in place
- Cup holder insert - Which clips into the base. Cup holder features a cutout to fit mugs with a handle as well as profiled bottom to hold regular and slim cans in place. Drink holder opening is 79mm or little over 3" (up top), 76mm or 3" (at the bottom) and 70mm or 2 3/4" deep.

Having base and cup holder as separate units, provides few advantages:
- Cup holder can be removed if it gets in a way of passenger or is temporarily not needed.
- Future expansion - phone mount, additional gauges (remove for street use, put in for track day), etc (Please message me if you have ideas)

Installation does not require any tools or modification and it's 100% reversible.
- To remove existing trim piece, use your fingers to pull away starting at the bottom at the front or back, it may require little force as these clips hold it tight. Don't bend upwards too much. Once bottom clips let go, slide fingers under to release the remaining ones. As a reference for location of the tabs use RENNDITION base.
- Make sure all 4 rectangular holes in center console have the metal clips, if some are missing you will need to purchase replacement, P/N for those is 99950747601. It's important to have all 4 in good shape to keep the base snug and secure.
- Snap new base in place straight on, making sure tabs are aligned with holes
- Finally slide the cup holder all the way in.
- Enjoy your favorite drink while you take the car for a spin :)

NOTE:
1. This item is 3d printed using ASA plastic which is suitable for car interior. Expect slight layer lines, and occasional small imperfection - these are normal and expected with FDM printing.
2. Grey plastic option is lighter than grey car interior.

You will receive all that is necessary:
- Base mount
- Cup holder insert

*B-stock - occasionally I will designate some parts as B quality, you can expect slight imperfections if surface finish and/or slight discoloration from glue residue. These are fully functional, but may require some touchup (perfect candidate if you are planning to paint it). Message me for pictures.