Super Commando Officer 3.75" 3D printed resin action figure, unpainted and unbuilt model kit StarWars inspired

English:
Warning: this model is extremely fragile and is intended for experienced model builders.

3D printed resin unpainted figure, 1/18 or 3.75". Needs cleaning of the supports, building and painting.
Please note that due to the fragile nature of the resin, this figure can't be considered as a toy and doesn't suit for children before 14.

As many of our beloved characters never got the figure they deserved, I try to fill this gap by making them myself.


Material: gray photopolymer resin
Height: approximately 10 cm
Units: 10
Joint points: 5

Notes and cautions:
-Fits the 3.75" toy range.
-Figure to build and paint.
-The final product might vary slightly from the photos.
-Handle the material with care, the resin can break easily.
-After printing the resin can encounter some slightly shrinkage, making the fitting of the different parts difficult. It is recommended to use a mini drill and sanding tools to widen the female half of the joint. On the opposite, if a joint is too loose, adding some material around the male half of the joint can help to get the right grip. I personally apply a few points of cyanoacrylate around the peg that I let dry before putting it back in place. If the joint is still loose repeat the operation.



French :
Please note, this model is very fragile and is intended for the most experienced model makers.

Unpainted printed resin figure in 1/18 or 3.75" scale. Requires preparation, construction and painting, the figure is delivered on its supports.
Please note, due to its fragile nature, this figurine cannot be considered a toy and is not suitable for children under 14 years of age.

As a good number of characters have never obtained miniatures in their likeness, I am working to fill this void.


Material: gray photopolymer resin
Height: around 10cm
Number of pieces: 10
Point of Articulation: 5

Notes and Disclaimer:
-Scale compatible with 3.75" action figure ranges
-Figure to assemble and paint yourself.
- The final product may vary slightly from the photos shown
-Material to handle with care can break easily
- After printing, the resin may undergo a slight shrinkage process which makes it difficult to fit the parts together. The use of a mini drill and sanding tool is recommended to enlarge the female half of the joint. If conversely the joint is too loose, adding material to the male half may help achieve the desired grip. Using a few dots of super glue works great for this, let it dry before repositioning the peg in place.