Gen 3 (2022-Present) Toyota Tundra/Gen 3 (2023-Present) Toyota Sequoia Phone Mount:
* Fits either multimedia option - large or small screen.
* Fits phones with case up to 15mm thick, approximately 80mm wide, and any length.
* Non-destructive installation and removal. No adhesives, screws/fasteners, etc. required! All parts snap into place, fit perfectly to the vehicle, and can be removed without any damage or modification to your vehicle.
* Clamp your charging cord into the mount, slide your phone in to secure and connect to charging. Connection only takes seconds!
* Enjoy fast charging and connection to Android Auto or Apple Car Play via cable vs. slow/poor wireless performance.
* Extra molded-in cable clips added to back of the mount for rear cable routing.
* Cable management clips included! Route your cable around CTR stack out of the way of vents, controls, cupholders, etc.
WHAT'S INCLUDED:
* Phone Mount with perfect fit to Gen 3 Tundra/Sequoia featuring Molded in Cable Routing Clips
* Bolt and Wingnut for clamping charging cable into place
* Passenger side UPPER cable routing clip
* Passenger side LOWER cable routing clip
* Charging cable is not included, but almost any cable works with this mount/system (USB-C or Lightning/Apple is preferred for easiest insertion/removal)
To use:
FULL INSTALLATION INSTRUCTIONS: https://youtu.be/Y9pGTPiQmzw
1. Insert charging cord through clamp and attach to phone.
2. Place phone in mount.
3. Tighten charging cord clamp (wingnut).
4. Ensure fit is well aligned by removing and inserting phone a few times.
5. Clip cord into molded-in routing clips.
6. Install into vehicle by snapping into top vent opening on left side of multimedia display.
7. Plug USB into data jack for Android Auto or Apple CarPlay connection.
Enjoy!
Check out my webpage:
https://3dcustomdesigns.com/
PLEASE NOTE:
* This will not fit over aftermarket parts.
* This is a 3D printed part. There will be layer lines and some surface imperfections vs. an injection molded plastic part. I have optimized the print so most/all imperfections are hidden from view once installed in vehicle, but there still may be some (but very few/none) visible to the customer. Please be advised.
* Printed from ASA, temperature resistant up to 95 degrees C (203degrees F).
If you are not satisfied with your order, please contact me via Etsy so we may resolve the issue together.