SP14/SP15 Moon Phase Clock Parts Kits

This kit includes all the non-printed parts for the SP14 Large Moon Phase Clock and SP15 Medium Moon Phase Clock except for the weights. The STL files can be purchased at https://www.myminifactory.com/object/3d-print-large-moon-phase-clock-362741 or https://www.myminifactory.com/object/3d-print-medium-moon-phase-clock-506795 and 3D printed on your printer. Both clocks use the same parts kit.

The kit contains all the parts shown in the pictures with a few spares where appropriate.
The metal arbors have been cut to length and deburred.
The flat for the minute hand has been machined.
The bearings have been cleaned and are ready to install. A spare 623 bearing is included.
The two heavy springs work great for the friction clutches.
The three smaller springs are for the ratchet.
Drill bits for properly sizing the arbor holes are included.

You will need to provide lead or steel shot (BBs) for the weight shell plus pennies or small washers for the pendulum bob.
A few small hand tools may be helpful, including a Phillips head screwdriver, hand files or sandpaper, and a pin vise for the drill bits.

The complete list of parts includes:
45 #6x3/4” flat head wood screws
2 #8x1-1/2" pan head screws
12 M3x8mm socket head screws
1 2.5mm hex key
6 pieces of 3mm stainless rod cut to length
9 pieces of 1.5mm music wire cut to length (some spares)
1 1/16" drill bit
1 1/8" drill bit
5 pen springs
2 608 bearings
4 623 bearings (one spare)
12' (3.6m) fishing line