Pythonicus Armageddon - Stationforge

Made by ThePeckingOrder

This listing is a printed version of a stationforge unit. With a authorized merchant license by the stationforge merchant tier on Patreon.

Bases are not provided

These will be printed in high quality ABS-Like Resin, this is a important distinction, as normal resin has the tendency to be more brittle/fragile, ABS-Like resin instead of being brittle/fragile will be more bendy instead and more resistant to damage from dropping. These prints will also be made by anycubic mono X2s and the M5S.

To see the quality of miniatures to expect you can check out https://thepeckingorder.org/3d-print-requests where I have a bunch of other prints I have done for people. Which for personal print requests outside of this listing you may request there.

Models will be printed, washed, and cured. You may have some lingering supports, they are very easy to remove via a hobby knife, some with your finger. These may come in parts or come whole, so some assembly may be required. These minis are washed in 90% alcohol and sometimes there could be some left over residue, if by chance this happens, just use warm soapy water, comes off easy! Many also suggest always washing resin minis before priming. If also for some reason the minis do not seem fully cured, just leave in the sun for a couple minutes, that is all :).

Bases are not provided.

These are also labeled as on-demand. They may be printed as ordered if there is no backstock of them.