PETG ZWO SeeStar S50 Telescope Dew 5" (131mm) Filter Holder 2" 1.25" Dovetail Mount Solar Finder Assist Cap Cover Spike Diffraction Bahtinov

This is the most versatile accessory set 3D_Print with PETG material for users who want more durability, higher temperature resistance, and less brittle than PLA material. According to the filament manufacturer, the heated distortion temperature for PETG material can hold up to 70°C/158°F, while PLA can only up to 50°C/122°F. The reason for higher prices is that the Matte PETG material costs more and takes longer to 3D_Print compared to Matte PLA.

The Items for sale:

Items are 3D Printed in JAREES PETG Black Matte, Normal Orange PETG for the Solar Finder Assist, and the Black Cap Cover is in TPU (made of flexible filament).

QTY (1): Top/bottom pieces housing Slot Filter Holders for 2" Deep Sky Filters (M48x.75)
QTY (1): Spacer with hole and thread for 1.25-inch Filter (M28.5x.75).
QTY (1): Light Block (Dew) about ~5 inches (131mm) in height
QTY (1): Batinov Mask
QTY (1): Spike Diffraction 4 veins
QTY (1): Spike Diffraction 6 veins
QTY (1): Len Cap Cover directly fits on the S50 and fits in the off position. (made of flexible filament TPU)
QTY (1): Solar Finder Assist (Orange PETG)
QTY (1): Accessory Dovetail Mount with Thumb Screw
QTY (1): DIY Top/bottom pieces Third-party Solar Filter Film mount (Orange PETG, If you need this in Black/White send me a message)
I also included a few M3 screws in case you needed them.

If needed you can thread in a normal head M3 screw to the small hole on the 3DPrint part, which will bulge on the other side of the wall for tighter fitment. Do it slowly with some force applied for the M3 screw for it to thread-cut into the 3d print plastic. Over-tighten/force the screw will punch through the thin 3D print wall (~1mm thick). Then, remove the normal M3 screw and insert a headless M3 screw in place.

For the deep sky filter please counter Clockwise for the thread to line up, then thread in Clockwise, and not to over-tighten.

Due to the nature of the 3D print filament, it will still shine/gloss after 3D printing the parts in Matte PETG. But it is way less compared to None Matte PETG.

SeeStar S50Telescope, Solar Len Filter, other deep sky lens filter, EZ Finder II, and Stand not included.

Item will ship in 1-2 business days.

Disclaimer:

***NOTE*** Due to the 3D print nature of this product, your results may vary. Sorry, there are no returns or exchanges. I am NOT responsible for any damages to your EAA telescope due to the result of the use of this product. Shipping Costs Are Non-Refundable.***NOTE***