Oppai Factory High Clearance 4M Transmission Conversion Plate for CR18P

CR18P High Clearance Conversion to TRX4m Transmission Plate

Love you CR18P, but hate that there are no gear options or upgrades to dial in your rig?

This plate is just as it sounds, this is a custom designed transmission plate that allows you to install a TRX4m trans into your CR18P. You can install the plate in either motor point forwards ot rearwards orientaion so both the 180 and 370 Transmissions will fit.

This is also a high clearance plate which sucks the underside of the skid up 5mm to become flush with the framerails and decrease underside high centering and hang ups.

Works with stock driveshafts (snug fit on the 4M output shafts) and can be used with CR18 or SCX24 non D-Shaped shafts. It can also be used with TRX4m shafts if you want to do a portal delete. Most CR18s work with C10 spec shafts but you should measure your rig to confirm.

**Please note that if you are running your rig in the counter spinning shaft layout you will need to flip the rear diff and go back to a conventional setup.

Comes with instructions and SS hardware to mount the trans and is able to run both the stock m1.6 or m2 screws for if you are running stock or upgraded metal links.



Free Lifetime Replacements:

I understand that 3d parts have can be more susceptible to breaks over metal or injected nylon parts, so for as long as I am business I offer free lifetime replacements of any parts that break for any reason. Simply cover the shipping, and I can ship out any replacement part or parts you need to make your rig whole again. If you are international, I understand shipping costs more so I will give you multiple sets of whichever part was broken to save you if you have another accident in the future. All of my products evolve over time if I find a better method or update I can do to improve them. If you do have a break on an older ver. of the part, then I will supersede you to the current ver. for only the cost of shipping.

Disclaimer:

This is a 3D printed part. It is made from PLA+ Plastic. It has an inherent "layered" look and may require some slight modification if your vehicle is fitted with other aftermarket parts.

Please view my packaging and inspect the package BEFORE handing it to young children. While my logo is suggestive, it is not unsightly, but may require the approval of a responsible parent before giving it (and the small contents inside) to a child.

Due to a rather insane review I received, I need to state this, and be sure anyone else so inept HAD the opportunity to read this...