OTHER 2 INCH HEADS:
moldf1, https://www.etsy.com/listing/169777232
moldf2, https://www.etsy.com/listing/212627481
moldf7, https://www.etsy.com/listing/164450604
moldf24: https://www.etsy.com/listing/620184538
moldf25: https://www.etsy.com/listing/634019587
moldf26: https://www.etsy.com/listing/634019823

moldf2 can be used with:
FEET:
moldf9, https://www.etsy.com/listing/194529697
moldf12f, https://www.etsy.com/listing/267470150
HANDS:
moldf10, https://www.etsy.com/listing/194527347
moldf11h, https://www.etsy.com/listing/235155785
BOOT:
moldb18, https://www.etsy.com/listing/228534032 

This face, and all of the variations in the 3rd photo, were created from a mold. And yes, you can do it too!

Use the mold to create a 2-inch tall face, then use the face to make art dolls, ornaments, wall sculptures. Turn it into an elf, a leprechaun, a troll, a gnome, a storyteller or a character of your choice.

Caution: Our silicone rubber is not FDA approved for use with food products. Use this flexible silicone rubber push mold with polymer clay, paper clay, air dry clay or other moldable materials to create a profile face that is approximately 2 inches tall.

The original model for this face was sculpted by Maureen Carlson. The molds are reproduced by Dan Carlson for Wee Folk Creations and are packaged under the trademarked name What a Character. You receive the mold and basic instructions. No clay is included in the package.

Note that this is a profile face only. Use your imagination to design various uses.

Copyright Notice:
@2012 by Wee Folk Creations
Purchase of a What a Character face mold entitles the owner to create that face for personal use or to sell in one-of-a-kind creations. This use has been surpassed when quantities greater than 20 are produced by hired employees for purposes of mass marketing. Face designs that are "tweeked" or slightly changed to mass produce derivative molds is strictly prohibited.