Holders for Ryobi USB Lithium Detail Scrubber FVG52 and Accessories, Garage or Workshop Organization

These hold both the Ryobi USB Lithium Detail Scrubber Model FVG52 and it's related accessories that can be mounted to the wall, pegboard*, or Ryobi Link Wall Rail. The Scrubber Holder holds the main tool and 2 accessories vertically. The Accessories Holder is holds 6 tool accessories at a 45-degree angle and 12 scour and sponge pads (6 in 2 slots).

No tools nor accessories are included. No screws, Ryobi Link Wall Rails or other items that may appear in the photos are included. These were designed to only work with the Ryobi USB Lithium Detail Scrubber FVG52 and it's related accessories.

The scrubber and accessories holder can fit in adjacent slots on Ryobi Link Wall Rails (see photos). Both holders are the same width, so the tool holder can be mounted above the accessories holder. The tool holder needs some space above it to lift the tool out of the slot.

If mounting to a wall/surface with screws or Ryobi Link Wall Rails, pegs stay recessed on the back and are not used. If mounting on pegboard*, pry pegs (with a small flat screwdriver) out and push into the holes. 2 curved pegs go into the top holes pointing upward and 2 straight pegs go into the bottom holes. We recommend you superglue them into place. 2 extra pegs (one curved & one straight) are included. If mounting to the Ryobi Link Wall Rails, it can be used with or without an additional screw (not included) to hold it into place.

* Note that there are many different types of pegboard and some may not work. This was designed to work on 1/8" thick masonite pegboard with holes at 1" (25.4mm) on center only.

Dimensions:
Scrubber Holder & 2 Accessories: 4.9" x 2.3" x 5.0" (123mm x 59mm x 126mm)
Accessories Holder: 4.9" x 2.3" x 5.6" (123mm x 59mm x 143mm)

These are uniquely designed and 3D-printed by the Seller in the USA. There is no warranty and are sold as-is. Items are lightweight and made of PLA plastic thus we cannot warrant that deformations or failure may occur due to extreme temperatures, stress, or weight. If you want this printed in PETG plastic which has greater resistance to heat, please let us know before you order. Due to the printing process, there may be some minor imperfections which are mostly likely to be on the bottom/back side, not exposed to view. 3D Printing involves the heating and depositing of material on a flat board one layer at a time, thus most exposed sides have small, fine lines. Infill (non-exposed) areas are not solid plastic.