Space container with locking lid

PLEASE READ:

This is a 3D printed (PLA PLUS) in universe storage conatiner/jug. The jug is built with a locking lid and articulated side handles. Please note that this is made of plastic and the handles should not have a large amount of weight on them.

This listing comes in two options. Option one is an unpainted raw print that will need to be finsihed and painted by you. With the raw print option, youll need to assemble on your own. Option two is a fully finsihed and painted version like what is seen in the photos. The paint finish includes a clear protective coating.

IMPORTANT NOTE: The lid uses gravity to lock. When closed, lift up slighly and twist counter clock wise to release.

The finished piece is approximately 11 inches tall and 10.5 inches wide.

please note that these are assembled by hand. I usually ship within a week, but there are circumstance where the finish time could be the full ship time estimated. All parts are checked thoughly for quality before they are sent out.

If you would like more than one or a bulk order, reach out to me for special pricing.

As always, if you’d like me to make a custom order for you, or have any questions, just reach out to me.

NOTE: PLA Plus is a thermal plastic that will become soft at temps around or above 200 degrees. It is not recommended to leave these items in a hot vehicle or outdoors in direct sunlight.