Boho Baby Shower Onesie Station Iron On Transfers, Baby Gift, 21 pc No. 2

Iron On Heat Transfer great for baby shower event..set up a Onesie Station and let your guest decorate a onesie for the new baby.

You will receive (21) Iron on Heat Transfer.....Design size approx. 2" to 3.5"...various size in betwee

Printed on Heat Transfer Paper..simply cut with household scissors
and following instructions below apply with household iron.

These are IRON ON HEAT TRANSFER applique ~ This is NOT a fabric transfer DTF / Vinyl transfer..
It is printed on Heat Transfer paper that you cut out and iron on.
Use only on WHITE Background
(these will NOT work on darker colors) -
Use cotton/cotton poly blends,
even woven fabric without Nap.

IMPORTANT
I only recommend using a household iron or regular heat press.
I do not know about handheld heat presses such as Circuits etc., although some customers have used them
and they seem to work. I have no information on using them and you have to use them
at your own RISK. I do put several samples for you to test with each order


Below are the instructions for ironing on your transfers...
as some irons are different from others...your timing my
vary from instructions...I try to include several
test samples for you to practice on
older onesies to see how your iron works with these
transfers before using them on your new onesies.
Please save these instructions for use when your transfers arrive..
You can also find these instructions in the listing and
on my policy page.

I have trimmed around the design, but you need to trim as
close to the edge as possible before applying.

Use an ironing surface that is waist level
or below (DO NOT USE AN IRONINGBOARD)
I suggest a board of some type that is
even and smooth) Place a Pillowcase over
it and smooth it out to remove wrinkles.


IRON ON INSTRUCTIONS:

1. Preheat Iron to highest setting for 5 Min.
Do Not Use Steam (Empty All Water)

2. Pre-iron onesie for several seconds to remove
wrinkle.

3. Place the printed design face down on the garment.

4 .Using FIRM, STEADY pressure, glide the iron in a
circular motion over the entire transfer for approx. 1-2
minutes. It's important to cover the entire transfer and
all the edges.

5. Glide the iron once more over the entire transfer to
heat evenly before peeling.

6. Timing of ironing may vary depending on the size of
the transfer and the temp. of your iron. You can use the
samples to see what works best for you.

PEELING THE TRANSFER:

While still hot remove the transfer by peeling slowly from one
edge....if you see that transfer has not completely adhered..carefully
lay it back down on the garment and reiron
Then repeel following the same steps above
until it is completely adhered.
After the design is completely applied...I would recommend using a sheet
of parchment paper, placed over the design and ironing for a
5-6 seconds.

WASHING INSTRUCTIONS.
Turn garment inside out, use mild detergent, cold water
Do Not Use Bleach..Dry on low heat and Do Not Iron On Design..
I recommended if it needs pressing to use a sheet of parchment
paper over the design if you need to press it.

Please note that the colors may appear slightly different depending
on your screen or printer settings, .

(IMPORTANT)
Please be sure and read all the information as I do not give refunds or cancelations...
unless it is a error on my part. Errors must be reported within 24 hours after delivery.
I do not guarantee a delivery date as I have no control after the Post Office picks up the package...
if you need it for a certain date, please give it at least two weeks for delivery or contact me
before you purchase. I usually mail the day of payment or the day after..although I do allow
1-3 days before mailing via USPS Ground Advantage Mail..which runs from 3-5 days delivery time..some times a little more or less.