Mason Jar Sleeve, PLA Vase Cover in Your Choice of Design and Finish

Turn a simple mason jar into a decorative flower vase with a textured, 3D-printed PLA cover. Choose your favorite design, then select from the available color finishes to create a combination that suits your space.

Slip a compatible glass jar inside, add water to the glass jar, and arrange your favorite flowers. The cover dresses up the outside while the removable jar holds the water.

CHOOSE YOUR DESIGN
• Botanical — raised leafy branches.
• Spiral — broad, flowing twists.
• Fluted — classic vertical flutes.
• Faceted — angular, geometric surface detail.

CHOOSE YOUR COLOR / FINISH
Mix and match any of the four designs with a color from the available options. Select your design and color separately when ordering. Each cover is 3D printed in black PLA. The other color options are spray-painted finishes applied to the outside of the cover.

The design-and-color combinations shown in the photos are examples. Your cover will be made in the combination you select. Surface sheen and texture depend on the selected finish. Painted finishes may vary slightly from piece to piece.

HOW TO ORDER
1. Check your jar measurements against the fit guide below.
2. Select Botanical, Spiral, Fluted, or Faceted.
3. Select your color from the available options.
4. Choose your quantity and add to your cart. For different combinations, add each combination separately.

WHAT YOU RECEIVE
One decorative PLA jar cover in your selected design and color.
Glass jar, flowers, and styling accessories are not included.

SIZE & JAR FIT
• Cover height: approximately 160 mm / 6.30 in.
• Nominal interior diameter: 92 mm / 3.62 in.
• Usable interior depth: 155 mm / 6.10 in.
• Recommended jar width: 90 mm / 3.54 in or less at its widest outside point.
• For a rim at or below the cover brim, choose a jar 155 mm / 6.10 in tall or shorter, measured without its lid.

A jar about 155 mm tall gives the intended flush-rim look. Shorter jars sit lower inside the cover; narrower jars fit more loosely. Taller jars may extend above the cover.

The 90 mm width recommendation leaves clearance inside the nominal 92 mm cavity. Printed dimensions can vary slightly, so measure your actual jar and never force a tight fit. Jar capacity, brand, and “regular mouth” or “wide mouth” labels alone do not confirm compatibility.

HOW TO MEASURE
1. Remove the lid and screw band.
2. Measure straight across the jar’s widest outside point, including any raised lettering, shoulders, or rim.
3. Measure from the flat base to the top of the glass rim.
4. Compare both measurements with the sizing guidance above and the measuring image.

MATERIAL & FINISH
3D printed from black PLA plastic, with spray-painted exterior finishes for the other color options. Fine layer lines and small surface variations are part of the printed finish. Copper and stone-like descriptions refer to color and appearance; the covers are PLA, not metal, stone, or ceramic. Colors may look slightly different in different lighting and on different screens.

USE & CARE
Use a separate glass jar to hold water; do not fill the cover directly. Remove the jar for filling and cleaning. Wipe the cover gently with a soft, damp cloth and dry. Avoid soaking, abrasive cleaners, and scrubbing the painted surface. Keep away from high heat, hot water, dishwashers, and open flames. Intended for indoor decorative use.

A simple way to style fresh flowers, dried stems, or a small tabletop arrangement while giving an everyday jar a new look.