Pocket Clip Holder for Omi AI Pendant, One-Piece Round Clip for Shirt Pocket or Waistband, Fits the Silicone Cover, 3D Printed PETG

Designed by Schank Studio with AI-assisted design tools; printed and finished by us in Florida.

A slim, round holder that lets you wear the Omi AI pendant on a shirt pocket or the waistband of your pants instead of around your neck. The pendant stays in its own silicone cover, slides in from the top and clicks into place. The front ring keeps the face and the light in view, and the sides are open so the rim of the pendant is not covered.

HOW IT WORKS
• Drop the pendant (in its silicone cover) into the top of the holder and press until it clicks past the side grips
• To take it out for charging, pull up on the cover's lanyard tab
• The clip is part of the holder, printed in one piece, so there is nothing to slide off or lose

THE CLIP
• 12 mm wide, slips over a shirt pocket, a button placket or the waistband of your pants
• Opens about 4 mm at the top, sized for regular shirt and pants fabric
• Wearing a jacket or a heavy work shirt? Tell us the thickness in the optional box and we will size the clip gap to suit

SIZE
• About 33.5 mm (1.3 in) across and 20 mm (0.8 in) deep including the clip
• Made for the Omi pendant in the silicone cover that comes in its box (cover about 30 mm across)

GOOD TO KNOW
• Printed to order in PETG, a tough plastic that flexes without cracking, so the clip keeps its spring
• Printed on its side so the clip's layers run along the bend, which makes it stronger
• Fine layer lines and small marks where print supports were removed are a normal part of a 3D-printed piece
• Each holder carries a small Schank Studio mark on the back, behind the clip
• Our own original design. Not affiliated with or endorsed by Based Hardware or Omi
• The pendant and its silicone cover are not included

Please allow 3–5 business days before your order ships. Questions? Send a message.