Here we have another fantastic deal from Proops Brothers Ltd, buy as a set and save!

Made by our parent company Linic Plastics Ltd here in Fleckney, Leicestershire.

4 sided pyramid candle mould with removable stand/base.
Mould produces candles approximately 4" tall, with a base of 3" square.

Rocket shaped candle mould:
9 1/2" long. 7/8" at top. 3/8" at bottom.

Sphere candle mould:
3" in diameter

If you are new to candle making or have not used rigid plastic moulds before here are a few tips to get a good finish: Use candle mould seal putty (or you can use a little piece of bluetac) to cover the wick hole and any seams, this keeps the wick still and stops any wax escaping. You can get mould release spray from craft shops. This is good to coat the mould before you use it, but you can also use a little olive oil spray too. Remember not to pour in your wax too hot and pour slowly. Allow the candles to set fully before trying to remove - at least 24 hours. If still a little tight to the mould after this time, ONLY WHEN FULLY COOLED AND SET, pop into the fridge for a short time, this shrinks the wax a little and the candles should just pop out. We hope this helps.

PLEASE NOTE, YOU WILL ONLY RECEIVE THE CANDLE MOULDS. THE CANDLES AND OTHER ITEMS SHOWN ARE FOR VISUAL REFERENCE PURPOSES ONLY.


We have these listed in a singles too check out our other listings.