FREE SHIPPING - The L3 Sconce is a modern sconce made from solid, unfinished brass.

- Hand made to order with unfinished brass parts

- Socket is standard E-26 Base

- Pictured with 25W G16 medium base bulb (not included)

- Base is 5" wide in diameter

- All mounting hardware is included

* Sconce can be hard-wired (as pictured) or wired with a cord, switch and plug for installation without a hard-wired box available on the wall. See the "Hard-Wired or Cord & Plug Options" drop-down for available options. Please contact me with any questions.

* Sconce ships via USPS Priority Mail. Minor assembly required upon receipt (you have to screw the arm into the base prior to installation - no tools required and difficulty level is SUPER easy)

* Please note the following information in regard to "unfinished brass": Unfinished brass means the brass is in a natural state after manufacturing. Nothing more has been done to the brass to finish it. Many People use unfinished brass parts as they are, to give a old antique feel. The brass is dull, may have manufacturing marks such as small scratches or scrapes. The brass could have manufacturing oils or grease. This can stain the brass in some places. The brass can be tarnished. After manufacturing , when brass is not sealed with varnish or lacquer, oxidation can start darkening the brass. Since parts are manufactured at different times unfinished brass parts can be at different states of aging. This would make unfinished parts not match each other when purchased. Dirt, grime, fingerprints, and slight traces of oxidation can be removed using a solution made up of 50% lacquer thinners and 50% water. Scratches can be removed with different grades on Scotch-Bright Pads. Others will professionally finish the brass by polishing or brushing or staining with patina. A Varnish or Lacquer is usually applied afterwards to seal the brass and stop the oxidizing. A wax is sometimes used instead of lacquer for a more environmentally friendly finish.