So of course, your order doesn't actually take weeks to print! Most orders can be printed in 1-3 days, however 3D printing is slow and that means we are constantly backlogged with orders that came in before yours! Most single prints take 4-6 hours on average, and we have 3 printers going most of the time (unless 1 or more are in need of repair).

So, to make this long answer shorter, orders are printed in the order they're received, and we are constantly backlogged from other orders.

Etsy also doesn't allow us to set longer timelines based on the number of pieces of ordered. So if you order 1 print, and someone else orders 20 prints (it HAS happened), Etsy will set the same timeline for both, and that 20 piece order REALLY slows us down!

The short answer is: when it's done. We don't say that to be harsh, it's just the reality.

We've set the timeline to what it is because of the above (orders coming in faster than we can print them) and because this is a side business. We do our best to ABP (Always be Printing) but we also like to have a life on the weekend and after work hours, at least occasionally!

Climbing holds usually ship in 2-4 business days.

As we're a small business, we cannot have a large inventory of every option and every color, so we do a "made to order" system where once you order, we make your holds and then ship them out!

These are just general guidelines, but here's some information for you!

Canada/USA: Usually between 1-2 weeks

International: 3-12 weeks. There's a big range here and Covid made it worse. We've seen up to 3 months for some orders, but many fall in the 2-4 weeks range.

Our holds are made of Polyurethane Resin and dye (unless you order Eggshell white). We add a washer to every bolt on hold that becomes part of the hold and increases the safety and stability of the hold.

The way we make our holds is usually different than most, because we 3D print the models first we have to add texturing agents to the design after 3D printing and then create the mold from that.

This results in texture made from positive bumps versus negative. In other words regular climbing holds typically have little bumps or bubbles inside the hold while ours have them on the outside. Your hand really won't be able to tell the difference though. The good thing is, you can sand our holds down a bit if you want a smoother surface. You can't do that with other holds!

We are a small business and therefore we cannot do break test on our climbing holds.

The buyer assumes all risk when using our climbing holds.

That being said, we are confident enough that we offer a 1 year warranty on holds and we use them ourselves.

Our holds are made from Polyurethane Resin, the recommend resin for climbing holds. The resin has a tensile strength of 3,000 psi (pounds per square inch) or about 20,685 kPA. Even our smallest foot holds are about half a cubic inch so capable of holding almost 1,500 lbs.

While our quality is great, aesthetically it's just slightly lower than big box hold producers, but it's close. The strength and durability is just as high. The main reason our holds are so cheap is we operate out of our home doing small batch holds with almost no overhead costs. However because we are small batch and small business, we do ship items that have minor cosmetic issues. This could be a small dot of another color on your hold (usually no larger than pin sized), a hold that has very minor surface imperfections, or a hold that might have a small piece of dirt, dust or even pet hair embedded in it. We do care about quality and all of these examples would only ship if it's very minor. Bigger imperfections get sold at a discount!