**In an effort to constantly improve our products and quality we have redesigned this pin board. The board will be the same as always but changes have been made to the walls and backer to increase stability and rigidity as well as improve the ability to hang the board on a screw or nail. The primary picture will be the new design and all other photos will remain to show the different colors we offer. Eventually all photos will be phased out and this notification will be removed. Thank you for your understanding and continued support! Happy Pinning! =] **
Why hide your park pins, when you can display them!
Each Pin Board is 3D printed using PLA filament frame with a cork face and foam interior backing sealed with hot glue/adhesive. This specially crafted interior allows for pins to sit securely in place. It also comes with a hole built in on the back on the board for easy wall hanging.
This pin board can hold approximately 15-25 pins, but may vary due to pin size and spacing.
PRODUCT DIMENSIONS/DESCRIPTION:
- 8" high, 9.5" wide and 5/8" thick with approximately 8 1/2 inches of usable cork.
- Dimensions vary based on size. Boards are 5/8" thick.
- Cork material (1/4" thick) is adhered to foam (1/8") for rigidity.
- Backer is sealed with hot glue to secure it in place. (Excess hot glue is cleaned but may be visible.)
- Printed on a textured surface to provide a unique finish.
- 3D Printed plastic accents. (Note: Pins will not be able to go through the accents and must go around them.)
- Metal hanger for wall displays are pre-installed on the backer for easy hanging.
DISCLAIMER:
- Design subject to change.
- Color and pattern of cork and/or plastic material may vary.
- Dimensions are approximate and may vary slightly.
- Premium Colors (Bottom two rows of color swatch) may have mismatched backers.
- Due to the nature of 3D Printing, minor imperfections are possible.
- Pins and/or accessories in the photo are not included and are for demonstration purposes only.
- Due to the thermal properties of PLA plastic used for the pin board borders, it is best to keep them out of direct sunlight or extreme heat.
We recommend keeping your pin boards under 110 degrees Fahrenheit/43 degrees Celsius. Extreme temperatures can cause the plastic to soften and warp.