This is a pair of button guards that helps prevent accidentally pressing the buttons on the Thomas Payne Theater seating cup holders.
There are a few different styles, 3D printed, 3D printed with a magnet top, and Acrylic.
Each order comes with button guard for 2 cup holders
***3D Printed: The guards are just less than 4mm tall, which is just enough to not be an issue for my wife pressing them with fingernails, and low enough to blend in nicely. The top is very smooth, and almost a matte black on top, which blends in well with the cup holders. Because they are 3D printed, there is a chance of some slight imperfections, however if there’s any issues, please contact me and I will replace them.
****3D Printed w/Magnetic Top: These are 3mm tall with a 2mm thick top with magnets on the sides to allow you to have the buttons covered at all times and easily uncover/slide the top over when you want to toggle a button on/off. *From the reviews, I've heard people wanted stronger magnets and i found some with twice the power & same size, so all magnet orders comes with the stronger magnets now.
***Acrylic: these are laser cut and have a great finished look, super smooth, black and 3/16" high (4.5mm), so just slightly higher than the 3D Printed ones,
All these buttons guards will come with 3M clear adhesive tape that’s laser cut and already on the buttons to make installation easy. Just clean the surface of the cup holder with alcohol, remove the adhesive backing and press the guard in place.
Some information about PETG if you’re unfamiliar with it. PETG is strong, durable, chemical resistant, wont warp or bend in the heat of the RV when in storage. PETG is a good-safe plastic that’s commonly used for food containers and water bottles and is fully recyclable.