Handmade Walnut Coat Hook: Modern Wall Decor with Concealed Fixings

Handmade Walnut coat hooks/pegs,

These hooks are made from FSC sourced Walnut which has been turned to a 30mm diameter.

The peg hooks are very easily fixed in to walls or doors and all fixings are supplied, each hook comes with a universal wall plug and have a die cast M6 fitting inserted into the hook. The fixings are a steel M6 screw with a TX15 drive recess for easy installation.

To install

1. Drill a pilot hole in desired location for the wall plug
2. Place the plug in the pilot hole
3. Screw the fixing half way to the plug
4. Screw the hook in to position on the remainder of the fixing.

Note: if fixing to a timber structure the wall plug isn't required. If fixing to plaster board walls please fix to stud and if that’s no possible make note order specific plasterboard wall plugs and I all including them. Note: load capacity of plasterboard alone is significant less than securing to a solid wall, timber frames or wall studs.

The timber grain, texture and colour may vary slightly as some are reclaimed. If you require a specific timber please let me know and I'll let you know what I have available.

Dimensions are:
Short : 6.5cm x D:30mm
Medium : 12cm x D:30mm
Long : 18cm x D:30mm
Long XL: 24cm x D:30mm

Angled or straight refers to how the hooks position against the wall.

Note: the listing is for single hook.

Manufacturer(s):

David Himsworth
thejourneymanandco [!at] gmail.com
22 Ripon Road
Ansdell
Fy84ds

Product safety:

Safety:
Do not stand on the product. Pregnant women should take additional care when using this product. Do not leave the children unattended. Children should always be under adult supervision whilst using the product.

Recycling:
Please ensure that the packaging is disposed of in a safe and environmentally friendly way and recycle where possible.

Care and Maintenance:

1. Only use a a damp cloth, do not use bleach or abrasive cleaners as they may damage the timber surface.
2. Do not use a very wet cloth or allow any liquid to contact with the surface for long periods of time. Wipe up immediately, liquids left on the surface can leave water marks.
3. Do not drag the piece when moving, lift it off the floor instead.
4. Use a beeswax, danish oil, Osmo Oil or similar to refinish and protect the surface finish (follow the product directions).
5. Do not place next to radiator or heat sources as it can effect the solid timber and cause it warp, shrink or discolour.