A new PAIR of light covers for the Marchal 750 driving lights on your Lincoln Mark VII, Four-Eyed Fox Mustang, or other 80's Ford equipped with these lights. These new covers snap on to the lights like the originals look great for show cars, and help to protect your priceless Marchal driving lights. They are not replicas but are designed to be an improvement over the originals as follows:
- 3.25 mm (1/8") thick front which is approximately twice as thick as the originals
- 1200*F heat shield included
- Details printed INTO the part vs a decal or paint
- Flat front with textured look
Covers are available in both Black and Grey, with white lettering. If you need another color combination, please message me to discuss it.
Tecmotion does NOT guarantee that these light covers will never melt if left in place with the driving lights on or fail under impact, however they have been tested and shown to survive the following scenarios:
- 30 minutes of "lights on" time with the covers and heat shield in place, car stationary and running and the driving lights turned on.
- multiple small rock impacts using a 3 elastic wrist rocket from 5 feet range.
What's included:
- TWO Plastic covers for Marchal 750 series driving lights.
- TWO pre-cut heat shields for use with the covers.
*** Note, the Marchal 750 lights and Lincoln Mark VII depicted in the product images are NOT included and are shown for reference only. You will receive two covers and two heat shields. ***
If you are in the Calgary, Alberta area, pickup at Tecmotion Chassis Dyno can be arranged - message me to make arrangements.
This is a 3D printed part made to the highest possible standards with a textured front surface finish that is ready to use right out of the box.